Watkins Caldera Spa Vacanza Series Owner's Manual download pdf (Page 30)

Normal soap build-up will require water replacement regularly enough that mineral deposits normally are not a problem.

Occasionally, high iron or copper content in the water may produce green or brown stains on the spa. A stain and scale inhibitor may help to reduce these metals.

NOTE: Well water may contain high concentrations of minerals. The use of a low water volume, extra-fine pore water filter will help to remove many of the larger particles

during the filling of the spa.

2. Foam Inhibitors (USE MONARCH DEFOMER)

Spa water requires changing due to the buildup of soap in the water. Typically, soap will cause the spa water to foam when the jets are used. Soap is introduced into the

spa water from two sources: users’ bodies, which retain a soap residue after showering, and swimming apparel, which retains soap after washing.

Foam inhibitors can suppress foam, but cannot remove soap from the water. Soap is very difficult to remove from the water because soap is not oxidized by any

chemical added to the spa. Only ozone can oxidize soap.

Eventually the soap build-up in the water will be concentrated, resulting in an unclean feeling on the bather’s skin, which is impossible to remedy. When this occurs, it’s

time to drain and refill the spa. Depending on the soap input, the water should last about 4 months before needing to be drained.

MONARCH

OZONE SYSTEM (OPTIONAL)

The MONARCH high output ozone system is the only ozone purification system approved for installation in your VACANZA

series spa. The MONARCH ozone system

utilizes Corona Discharge (CD) technology to produce a higher concentration of ozone than is produced by competing ultraviolet light (UV) ozone systems.

The MONARCH high output ozone system greatly enhances the quality of the spa water when used to supplement the spa owner’s regular water maintenance

program. Contrary to some information circulated throughout the pool and spa industry regarding ozone systems, ozone can not be used as a single-source sanitizer,

water clarifier, anti-foamer, and mineral chelating agent. Watkins Manufacturing Corporation recommends following the FROG sanitizing system when using an ozone

purification system to assure water sanitation and the highest quality of purified water.

Cleaning the Ozone Injector

On occasion, a mineral build up may clog the ozone injector, causing a lack of flow or low flow, of ozone bubbles. To prevent this, refer to the following instructions to

clean the injector:

1. Disconnect power to the spa.

2. Access the equipment compartment.

3. Place 16 ounces of white vinegar into a container such as a cup or bucket. Place the container on the equipment compartment floor. NOTE: White vinegar will not

damage any of the spa components.

4. Carefully loosen the long tubing to the bottom of the ozonator. A liquid substance may be found inside the tubing. If a liquid substance is present, BE

CERTAIN NOT TO COME IN CONTACT WITH THE LIQUID (SEE WARNING BELOW).

5. Place the end of the tubing into the vinegar, making certain that the end of the tubing sits at the bottom of the container.

6. Reconnect power to the spa.

7. Run the spa until all 16 ounces of the vinegar are gone. This should allow an ample flow of vinegar to be run through the injector and clear the blockage.

8. Disconnect power to the spa.

9. Remove the empty cup or bucket.

10. Reinstall the tubing to the bottom of the ozonator.

11. Close the equipment compartment door.

12. Reconnect power to the spa.

The MONARCH ozone system is practically maintenance-free because it is located within the spa’s equipment compartment. If bubbles are appearing at the spa’s heater

return, but the water is not as clear as usual, then the operation of the ozone generator should be checked by your dealer.

WARNING:

Contact your dealer if your spa requires troubleshooting beyond the scope of this manual. MONARCH ozone systems should only be serviced by a

qualified technician.

WARRANTY NOTE: Cleaning of the ozone injector is not covered under the warranty. Refer to the Ozone section of this manual for ozone injector cleaning instructions..

WATER QUALITY AND MAINTENANCE

Nitric acid accumulates in the air lines of the ozonator and injector. Nitric

acid will cause severe chemical burns if direct skin contact is made, so

always wear protective gloves, glasses and clothing when working on the

ozonator or injector lines. To prevent inhalation or ingestion of the nitric acid,

DO NOT blow or inhale with your mouth to any of the adapters, fittings or

tubing of the ozonator or injector air lines.

WARNING

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Comments to this Manuals

No comments

Watkins Caldera Spa Vacanza Series Owner's Manual Page 30

Comments to this Manuals

Related products and manuals for Above ground pools Watkins Caldera Spa Vacanza Series