Watkins Caldera Spa Vacanza Series Owner's Manual download pdf (Page 29)

• DON'T use a water clarifier; Clarifiers will cause the spa water to become cloudy.

• DON'T use the MONARCH silver cartridge with FROG.

CHLORINE (SODIUM DICHLOR)

(USE MONARCH CHLORINE)

A. Sanitizing chemicals, such as chlorine, are oxidants that kill bacteria and viruses in the water. The Free Available Chlorine (FAC) is a

measure of the amount of unused chlorine available to sanitize the spa. The recommended FAC for your spa water is 3.0-5.0 ppm.

B. Watkins Manufacturing Corporation recommends the use of sodium dichlor type granulated chlorine for sanitizing the water. Sodium

dichlor is preferred because it is totally soluble, dissolves quickly and is nearly pH neutral.

C. Maintaining the proper level of chlorine during use is extremely important.

D. If the FAC is too low, bacteria and viruses can grow rapidly in the warm water. Increase the FAC by adding granulated sodium

dichlor.

E. If the FAC is too high, the water can cause discomfort to the user’s eyes, lungs and skin. Simply allow some time to pass. The FAC

level will drop naturally over time.

F. When the Free Available Chlorine is within the recommended range, the spa is ready to be enjoyed.

SUPER CHLORINATION

Super Chlorination is a process used to eliminate chlorine smell (if you are using chlorine) by “burning-off” chloramines (used chlorine). This helps maintain the proper

level of free chlorine.

When giving your water a super chlorination treatment, open the cover at least half way for twenty minutes to allow the chlorine gas to vent off. The high concentration

of chlorine gas which may exist as a result of super chlorination (not daily sanitation) may eventually cause discoloration or degradation to the bottom of the cover, which

would not be covered under the terms of your warranty.

WARNING

: There are several forms of stabilized chlorine available for use in spas and swimming pools. Each form has specific chemical characteristics. It is

extremely important that the form you choose is specifically designed for use in spas. Use of an incorrect product such as tri-chloro, which has a very low pH (2.6),

dissolves too quickly in hot water resulting in extremely high levels of chlorine, and is designed for concrete or plaster swimming pools, WILL cause damage to your spa.

Use of a liquid, or any type of compressed bromine or chlorine, acid, or any type or sanitizer which is not recommended by Watkins Manufacturing Corporation, WILL

damage your spa and is specifically not covered under the terms of the limited warranty.

IMPORTANT: Granulated chlorine (sodium dichlor) will degrade if stored improperly. We recommend purchasing chlorine in one, two, or five pound containers and

storing it in a cool, dry place to maintain its potency.

WARNING

: Never leave an open spa unattended, especially if there are children present!

SUPPLEMENTAL WATER MAINTENANCE

Proper water sanitation and mineral balance (pH control) are absolutely essential for a complete spa water maintenance program. Here are two other popular water

additives that are optional:

1. Mineral Deposit Inhibitors (USE MONARCH STAIN/SCALE)

As water evaporates from your spa and new water is added, the amount of dissolved minerals will increase. (Minimize evaporation by keeping the cover on the spa

whenever possible.) The spa water may eventually become “hard” (Calcium Hardness too high) enough to damage the heater by calcifying its surface. Proper pH control

can minimize this.

WATER QUALITY AND MAINTENANCE

*MONARCH MPS and MPS Plus is an oxidizer, not a sanitizer

WATKINS

WATER TREATMENT GUIDE

At spa startup or refill

Follow spa Start-Up and Refill Procedures.

Prior to each use

(Test before adding any chemicals; do not add any

chemicals if proper or higher levels are found.)

Add one-half (½) teaspoon of MONARCH sodium dichlor per

250 gallons, OR Add one (1) tablespoon MONARCH MPS

Plus (monopersulfate)* per 250 gallons

Once a week

Add one-half (½) teaspoon of MONARCH sodium dichlor

per 250 gallons, OR Add four (4) tablespoons MONARCH

MPS Plus (monopersulfate)* per 250 gallons

Every four months

Drain and refill your spa.

Follow spa Start-Up and Refill Procedures.

As needed

(If water is hazy, cloudy or has an odor)

Add one and one half (1-1/2) teaspoons of sodium

dichlor per 250-gallons, as needed.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Comments to this Manuals

No comments

Watkins Caldera Spa Vacanza Series Owner's Manual Page 29

Comments to this Manuals

Related products and manuals for Above ground pools Watkins Caldera Spa Vacanza Series